glass cutting machine maintainess

Glass cutting machine automatically flow into the tank, open the tank, remove the water pump to remove dirt Pump. The water tank clean, replace good circulating water, the pump reverts back to the tank, connect the pump inlet pipe is inserted, and fold each connector. The pump is powered separately and run for 2-3 minutes (the laser tube filled with recycled water).

A fan cleaning

Fans prolonged use, will accumulate a lot of fans inside the solid dust, so fans have a lot of noise, not conducive to the exhaust and odor. When there is not enough poor smoke suction fan, first turn off the power, the fan on the duct and the air duct removed, remove the dust inside, and then the fan upside down, and Stubbs inside the fan until clean , then the fan is installed.

Two: Clean the lens (recommended daily job before cleaning equipment shall be turned off)

I remind you: glass laser cutting machine lens center to the edge of the rotary wipe. The 3rd lens and the focus lens needs to be removed from the frame in the same way, after wiping finished as Replace can be.

Note: 1. Gently wipe the lens should not be damaged surface coating (metal-coated lenses more durable wood); 2. Wipe process should be gently, to prevent falls; 3 Focusing mirror installation, be sure to keep concave down....

Third, the cleaning rails (recommended cleaned once every two weeks, shut down operations)

Rails, linear axis as one of the core components of the device, its function is to play a guiding and supporting role. In order to ensure that the machine has a high precision, requiring that their guide, linear guide with high precision and good processing quality glass cutting machine, should seriously carry out routine maintenance guide, linear axis.