YK-VIII glass frosting powder

YK-VIII glass frosting powder is fit for the deep processing of lamp glass, glassware with rigid materials. The technology is advanced, the operation is simple, the cost is cheap, the frosting surface is even and tender, which feels smooth and delicate.

Put 3kg of cold water into 10kg of glass frosting powder, stir it symmetrically in the plastic container. With the industrial sulfuric acid of 90% consistency, adjust the PH value of the solution to 2.0-1.0, which is tested by the accurate test paper in the range of 0.5-5.0. Then it could be put into the production after stirring fully.

The Process of Technology in Production?The clean glasswork dubmerge it into the solution for 1-3 minutes take out and wash it with clean water with washing liquid ash it again with clean water dry it.

1. Make sure the workplace is ventilated to discharge the waste air produced in the production.  2. The frosting solution must be prepared in plastic containers or those containers have been done with preservative treatment. 3. In the production, workers must wear rubber gloves to prevent burning skin, but if so, wash it immediately with clean water. 4. Be sure the surface of the glasswork is clean without any oil, wax and gluey impurities. 5. The quantity of sulfuric acid put into the frosting solution depends on the etching effects required. Whatever, be sure water first, then the sulfuric acid. 6. The solution must be fully stirred when it is put into the production, cover when store up.  7. Replenish the prepared frosting solution into the production when it could not produce the well-etched glass products. 8. If the first etching is not satisfied, clean it and etch the second time. 9. When discharge the sewage, put some quicklime in order to offset its acidity. 

Storage锛歍he glass frosting powder should be stored up in the dry and ventilated place to prevent the powder moistening.

More information, please contact us website: http://en.chinayuke.com/